3
Rollerdor RD20X2ELL Control Box, Edition 2022/1
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
1. INSTALLING RECEIVER BOX
(SAFETY EDGE)
1
Remove white plastic light cover by squeezing in each
side and lifting away
(fig.1)
.
2
Remove small plastic cover at the bottom of the unit to
reveal screws and then remove all 4 screws from cover
to reveal control board inside
(fig.1)
Warning: Take
care when removing front cover as there is a membrane
ribbon that connects it to the main circuit board.
3
Place the Receiver box on the wall with the cable
pointing downwards at a comfortable height to operate
the push buttons, but out of the easy reach of children.
Between 1500mm up from the floor and 300mm down
from the roof/ceiling is recommended, mark the 4
fixings, drill and secure the unit to the wall
(fig.2)
.
4
If you have a safety brake with a cable then run the
two core cable from the safety brake end across to
the same end as the receiver box, making sure to
securely fix the cable out of the way of the working
mechanism.
5
The Glands at the bottom are for the cables to be
inserted, (1) motor wire (2) power wire (3) safety brake
if supplied.
6
Wiring as follows
(fig.3 & 4)
:
Terminal 1
– Earth Motor Wire
Terminal 2
– Earth Power Wire
Terminal 3
– Power Brown Live Wire
Terminal 4
– Power Blue Neutral Wire
Terminal 5
– Motor Open Wire (left hand motor
Black / right hand motor Brown)
Terminal 6
– Motor Blue Neutral Wire
Terminal 7
– Motor Close wire (left hand motor
Brown / right hand motor Black
Safety Brake
(fig.5 & 6)
:
Terminal 21 - Safety Brake = Blue Safety Brake
Wire / No safety Brake = Link cable to Terminal
22.
Terminal 22 - Safety Brake = Brown Safety Brake
Wire / No Safety Brake = Link wire to Terminal 21.
fig.3 - Right Hand Motor
fig.4 - Left Hand Motor
fig.5 - Safety Brake
fig.6 - No Safety Brake
