Charging instructions
You must charge the battery for 24 hours before the first use;
only an adult should handle the battery and charger
9. Connect the Battery: (Fig 9)
(1). Ensure the vehicle is stopped and turned off.
(2). Unlovk and remove the seat.
(3). Locate the white battery connector(A) that attaches directly to
the battery.
(4). Connect the white battery connector to the white engine
connector(B).
(5). Replace the seat.
10. Charge the Battery: (Fig 10)
(1). Ensure the vehlcle is stopped and turned off.
(2). Unlock and remove the seat.
(3). Unplug the connect (A) from the connector (B).
Plug the charger connector (C) into the battery
connector (A). The light on the charger will turn
red to indicate that it is charging. Once charging
is completed, the light will turn green. Unplug
the battery from the charger and reconnect it to
the engine connector (B).
(4). Replace the seat.
11. OPERATING INSTRUCTIONS: (Fig 11/12)
(1)On/Off: Push the Power Switch to Turn on the Car.The power
indicator light will turn on when the car is on. Press the power
switch again to turn off the car.
(2)Foot Pedal: Press the foot pedal down to go. Release the foot
pedal to stop.
(3)Horn: Press the steering wheel buttons for horn sounds.
(4)Battery power indicator: Press the power indicator button to
check battery level.
(5)Three Lights: Battery is fully charged.
(6)Two Lights: Battery power is low.
(7)One Light: Battery power is lower than 10.8 V, and the battery
must be recharged.
(8)Speed and Direction: Pull the shifter to the middle to move
forward 4 km/h, 2.5 MPH. Pull the shifter all the way up to move
forward at 8 km/h, 5 MPH. Push the shifter all the way to the floor
to go in reverse.
(9)High-speed lockout: loosen the small screw at the base of the
shifter to allow the truck to go at the higher speed of 5 MPH.
Tighten the screw to only allow the truck to move at 2.5 MPH.
12. Install the phone holder: (Fig 13)
1. Take out the phone holder from the package.
2. Loosen the rubber band on the bracket and install the phone
holder in the position shown on picture (1, 2). Fit the rubber band
as shown on picture (3).
Fix the phone:
1. Pull the phone holder in the direction of the arrow shown on
picture (4).
2. Put the phone into the holder and release the phone holder to
fix the phone, as shown ion picture (5).
OPERATING INSTRUCTION
MAINTENANCE
1. Before assembly please check that you have all the parts, if there are any
missing parts please contact your local store.
2. Once assembled please inspect all the parts and ensure the vehicle is
working properly.
3. Please carefully clean the product occasionally and do not destroy any parts.
4. In order to keep your child safe, please inspect and maintain the vehicle
periodically.
CARE
