16
Assemble the Handle Bars
1. Remove the screw (26) and nut (24) from the steering rod.
2. Slide the handle bars (9) onto the steering rod. Ensure the holes on the
handle bars align with the holes on the steering rod.
Note: The Power Button should be on the front of the handlebar.
You may need to thread the wires partially through the wire
compartment to reach.
3. Insert the screw (26) and nut (24) into the handle bar, through the
steering axle and tighten with a screwdriver.
4. Carefully slide the handle bar wire connector into the wire compartment
where the motorcycle wire connector is located.
26
24