11
Assemble the Rear Wheels
Note: The right side of the vehicle will only have 1 washer. Locate the inner wheel
spacer (16), snap pins, (14) and large washers (15) from the blister box.
Left Rear Wheel
1. Slide the large washer (15) onto the axle.
2. Slide the inner wheel spacer (16) onto the axle with the wide end facing out.
3. Slide the left rear wheel (8) onto the axle with the gear teeth facing inward.
4. Slide the large washer (15) onto the axle.
5. Insert the straight side of the snap pin (14) through the hole at the end of the axle
to keep the wheel in place.
6. Position the hubcap (9) over the holes on the wheel, and snap the hubcap into
place.
Right Rear Wheel
7. Slide the right rear wheel (8) onto the axle with the gear teeth facing inward. Ensure
that the gear teeth connect with the gear box that is pre-installed on the axle.
8. Repeat steps 3-5.
8
4
17
14
16
Helpful Tip:
1. If you encounter
trouble fitting both
wheels onto the rear
axle, then your rear
wheel axle may need
to be realigned.
2. Remove both wheels
from the rear wheel
axle. Using two hands,
push down on the rear
wheel axle and slide
it gently toward the
side of the vehicle that
needs more room.
Summary of Contents for W458AC
Page 4: ...This page is intentionally left blank...
Page 26: ......
