Replacing the Battery
This organizer uses two CR 2025 3-volt Lithium batteries. Before you follow these
steps you should have a small Phillips screwdriver (one that fits into screws with an
“X” notch) and the new batteries at hand.
WARNING !
When no batteries are installed, this organizer will save your information for only
30 seconds. So quickly install the new batteries after you remove the old ones.
!
Steps to Replacing the Battery
1.
Turn on the organizer and enter the alarm mode.
2.
Press INSERT for 3 seconds.
3.
Press ENTER to confirm and enter the sleep mode.
4.
Eject the card from the main body.
5.
Remove the screw on the battery cover with the Phillips screwdriver and
then remove the lid.
6.
Remove the old batteries and quickly replace them with the new batteries,
with the positive (+) sides facing up.
7.
Press ON/OFF for 5 seconds to activate the organizer.
!
Replace the battery cover
WARNING !
If “RESET?” appears when you next turn on the organizer, do not press
ENTER
unless you want to reset the organizer and erase all your information.
!
Keep Written Copies of Important Data
WARNING !
Information can be lost or corrupted if you make a mistake while operating this
organizer. Therefore, always keep written copies of your important information in
case it is corrupted or lost.
This unit may change operating modes due to Electrostatic Discharge. Normal
operation of this unit can be re-established by pressing the Reset key,
ON/OFF
, or
by Removing/Replacing batteries.
