MANUAL
MANUAL
54
The chair pulls to one side
Wrong tyre pressure
Check tyre pressure.
Symbol appears in display
The system has reduced
effectiveness of the motors
to avoiding overheating.
Stop driving and let the
motors
cool down. They are
overloaded and subject to
a greater load than they
are designed for.
Symbol appears in display
The control system has
become too hot and has
reduced the power.
Turn the chair off and let it
cool down.
Other reasons
Contact ROLTEC.
Symbol appears in display
If the wheelchair is being
prevented from operating.
Turn the wheelchair off
and on again to use the
wheelchair.
(Contact dealer if
necessary)
Symbol appears in display
The system has generated
an error and shows a text,
module and an error code
Contact ROLTEC.
Symbol appears in display
Joystick activated
Let go of the joystick and
centre it to be able to use
wheelchair.
If you activate the joystick
before or at the same time
as powering up, the symbol
will flash.
If the joystick is activated
when the chair is powered
up, it cannot be driven. If
it is not returned to the rest
position within 5 seconds,
the wheelchair should be
turned off and then on
again.
JSM:
Number of light diodes
flashing:
Problem:
Solution:
1. The battery must be re-
charged
Put the wheelchair on charge
2. There is a poor connection
to the battery.
Check the connections to the
battery.
1. Poor connection to the
left* motor
Check the connection to the motor