25
The chair’s mechanical settings
⚠
Any mechanical settings of the wheelchair must not be carried out with the user in the
chair, and should only be carried out by personnel who are familiar with the chair’s design
and functionality.
Seat depth
Adjusting the seat depth is done in two stages:
1.
Positioning the height-adjustable seat
2.
Adjusting the back
Height-adjustable seat:
The height-adjustable seat can be positioned at 3 different levels A, B and C. This allows for
the following seat depths:
1
: 37-47 cm,
2
: 40-50 cm and
3
: 43-53 cm.
1.
Remove the 4 bolts holding the adjustable seat (Fig. 1 - Pos. A).
2.
Position the seat at the desired level - 1, 2 or 3.
3.
Replace the 4 bolts (Fig. 1 - Pos. A).
Back:
1.
Loosen the 2 bolts on either side of the seat (Fig. 1 - Pos. B).
⚠
: The bolts must not be removed, just loosened.
2.
Move the back forwards or backwards to the desired position.
3.
Tighten the 2 bolts (Fig. 1 - Pos. B).
Figure 1
B
A
A
A
1 2 3
A
