Continued…..
To
achieve
the
correct setting the
brake shoe should be
set at a gap of
approximately 2-3mm
from the wheel (a 10p
coin can be used as
shown in the image).
Model 2330
Rollator model 2330 uses a push down
type brake where the user physically
pushes down the rear of the frame to stop
the rollator.
The force required to push down the rear
frame can be adjusted by the brake
tension adjuster as shown opposite.
Turning this clockwise will increase the
force required, turning anti-clockwise will
decrease the force required.
Model 2467
This model also has further
adjustment at the brake as
shown opposite. Turn the
adjuster
screw
anti-
clockwise to increase the
tension in the cable then
lock the adjustment by
turning the locking nut
clockwise whilst holding
the
adjuster
screw
staionary.
Brake adjustment reduced to allow light pressure may be ineffective on the
brake in the locked position.
Summary of Contents for 2320
Page 15: ...Notes ...
