1. Disassemble the panel side location cup, and screw the brass insert into the profile on top the curved glass panel, then re-
assemble the cup onto the brass insert. Don't tighten the allen key yet.
2. Determine the location of the wall cup using the full brace bar assembly. Push the brace bar into location in the panel cup
and slide the wall cup on the other end, mark the location using a pencil.
•
Make sure the brace bar is level. (The bubble should be in the centre of the two lines on the spirit level).
3. Remove the brace bar and unscrew the brass insert from the wall cup. Hold the insert concentric to the pencil mark and
mark the drill hole location.
4. Drill the location hole using a 6mm masonry drill bit and insert the wall plug.
5. Fix using a 40mm screw and then screw the wall cup onto the brass insert and tight up to the tiles.
6. Re-assemble the bracing bar into the panel side cup and the wall cup.
7. Tighten all the grub screws in the wall and panel cups using an Allen key when you are satisfied the brace bar has been
adjusted correctly.
-
There is 25 mm of adjustment in the brace bar to allow correct alignment.
-
The brace bar must be level (The bubble should be in the centre of the two lines on the spirit level).
-
The Front Panel must be vertically level, make sure the brace bar is adjusted to achieve this.
(The bubble should be in the centre of the two lines on the spirit level).
Step 4 - Assemble the Brace Bar.
FC:CQB
4/5/10
12:13 Page 5
