1. Clip on the wall profile cover trims. (They are designed to be a tight fit so take care).
2. Place all the cover caps on the profiles. (R and L on the inside of the caps indicate the handing of the caps looking from
the outside of the enclosure)
3. Stick on the Roman Branding Badge.
4. Seal vertically the full length of the wall profiles/wall profile trims where they meet the tiles on the inside of the
enclosure, using bathroom sealant. Also seal vertically the full length of the wall profiles where they meet the tiles on
the outside of the enclosure, using bathroom sealant.
5. Seal horizontally the aluminum profiles and the glass panels on the outside of the enclosure, at the bottom where they
meet the tiles and the tray, using bathroom sealant..
•
(Please leave the sealant 24 hrs to cure before use).
IMPORTANT:Failure to carry out the procedure in Steps 4 & 5 can cause serious water damage and is not
covered by the guarantee.
•
If you are fitting the enclosure with integrated water delivery, please refer to your valve instructions to complete
the installation.
Step 5 - Fix the Cover Caps and Seal the Enclosure
FC:CQB
4/5/10
12:13 Page 6
