Step 2 - Wall Profile Fitting (Alcove) 1st Wall Profile
1. Decide which side of the alcove that you wish to position the fixed/panel side of the door.
2. Position the first wall profile approx. 15mm in from the front of the tray.
3. Using a pencil mark the locations for the drill holes through the lip of the wall profile.
4. Drill the holes using 6mm masonry drill bit (not supplied). Push the wall plugs (supplied) into the drilled holes.
5. Apply a bead of silicon the width of the wall profile at the bottom where it meets the tiled wall.
6. Screw fix the wall profile to the wall using the 40mm screws (supplied).
7. Apply a bead of sealant to the inside of the wall profile at the bottom where it meets the tray top.
Important:
The wall profiles must be completely vertical (the bubble should be in the centre of the two lines on the spirit
level). The sealant must be applied in steps 4 and 6; failure to follow out this procedure may result in serious
water damage and is not covered under the terms of the guarantee.
Important:
If fitting the product in conjunction with a side panel please ensure that both wall profiles are fitted as shown
above using the method explained in Step 2.
➀
➁
➂
➄ ➆
➅
➃
ET Sliding Door:CSP 4/5/10 11:33 Page 4
