TROUBLE SHOOTING GUIDE
Some important information to help you Maintain your product.
The following information is all you need to keep your product looking new.
Clean your product using a mild detergent diluted in water and then polished off using a soft cloth.
If you live in a hard water area, periodically clean your product using a 50/50 solution of white vinegar and water. The
solution should be left on the enclosure for approximately 5 minutes then rinsed off using warm water. This method of
cleaning should remove lime scale residue.
Simple Maintenance
Our products are generally maintenance free, however it may be necessary to lubricate wheel assemblies and other
moving parts from time to time.
It is strongly recommended that a quality silicone spray is used.
A list of Don’t’s:
1. Don’t use acidic based products which are unsuitable for cleaning enamel surfaces.
2.
Don’t use abrasive cleaners or cleaners using bleach or solvents, these products will adversely affect the finish of
the aluminium profiles.
3. Don’t use scouring pads, powder or any sharp instruments when cleaning the enclosure.
Should you experience any problems during installation please refer to the
Trouble Shooting Guide or contact Customer Relations on:
+44 (0) 1325 328033
To enable customer relations to provide you with an excellent level of service it is important that you
quote your product Code and Reference Number - these can be found on the Guarantee card.
Problem
Solution
Leaking
1.
Check that the inside gap between the Tray and Wall Profile has been sealed correctly.
2. Ensure the tray is sealed along the tiled walls prior to installation.
3.
Ensure the Wall Profile is sealed vertically inside and outside.
4. Ensure the joint between the enclosure and tray top is sealed.
5.
The deflector on the Bottom Seals is semi rigid and can be carefully altered to offer
more deflection of the water.
6. Check the Magnet Seals are locating and there are no gaps.
Important: This enclosure should be water tested conforming to BS EN 14428
Enclosure Alignment
on the Tray
1.
Is the enclosure fitted onto a tiled wall?
2.
Is the Wall Profile fitted 15mm from the outside edge of the tray?
3.
Is the Wall Profile completely vertical?
Panel not operating
correctly
1.
Ensure the Wall Profile is completely vertical.
2. Ensure the tray is completely level.
