6
GRID
portable power pack
44ah
WHEN THE POWER PACK IS IN USE and the voltage
decreases to 10.5V, the unit will automatically
switch OFF and the Low Voltage Warning indicator
(RED) will commence flashing with an audible single
beep every 5 seconds for 10 minutes and then
remain illuminated.
WHEN THE POWER PACK IS STORED AND
NOT IN USE and the voltage decreases to 11.5V
a single beep will continue every 10 minutes as
a first alert warning to charge the Power Pack.
If the Power Pack is not recharged and the voltage
continues to decrease to 10.5V, the unit will
automatically switch OFF and the Low Voltage
Warning indicator (RED) will commence flashing with
a single beep every 5 seconds for 10 minutes.
The Low Voltage Warning indicator (RED) will then
remain illuminated and the audible beep will stop.
IMPORTANT: THE POWER PACK MUST
NOW BE RECHARGED - FULLY RECHARGE EVERY 3
MONTHS.
To restore power to the digital display screen or
the on/off switches, press the RESET switch
before recharging.
Note: All appliances and any charging adaptor
(or solar panel) must be disconnected from the
Power Pack for the RESET switch to operate.
IMPORTANT: STORE FULLY CHARGED
to maximise performance and battery life of
the Power Pack.
Charging the Power Pack:
1) Using the 240V AC charging adaptor (included);
Insert the 5.5mm Jack Plug into the ‘Charge Input’
socket (7) on the front of the Power Pack and other
lead to mains 240V AC. The ‘Charging’ LED (10)
indicator will illuminate (GREEN) once the power is
turned on indicating that charging has commenced.
The fully charged indicator (11) will illuminate
(YELLOW) once the Power Pack is fully recharged.
Estimated charge time using the 204V AV adaptor is
approximately 8-10 hrs.
2) Using the 12V DC charging lead (included);
Insert the 50A Anderson style plug into the ‘Charge
Input’ socket (8) on the side of the Power Pack.
Note: The ‘Charging’ LED (10) indicator and the ‘Fully
Charged’ LED (11) indicator WILL NOT illuminate
when the Power Pack is being charged by the 12V DC
charging lead.
Press the ‘DISPLAY SWITCH’ (13) to check the Power
Pack voltage capacity on the digital display (1).
Using the 12V DC charging lead (included)