STEP 1
Attach one of the stabilizing bars
(S)
to left side
(L)
of
the crib using 1 Allen bolt
(3)
, 1 washer
(8)
and 1
barrel nut
(4)
. Align the tenon attached at the end of
the stabilizing bar with the upper hole existing on the
inner face of the left side of the crib. Be sure that the
drilled face of the stabilizing bar faces towards the
inside of the crib (follow the instructions attached to
the stabilizing bar).
Push the barrel nut into the hole drilled in the
stabilizing bar then align the straight slot in the head
of the barrel nut horizontally, so the threads in the
bolt will insert in the barrel nut. You can adjust the
position of the barrel nut with a flat head screwdriver
(not supplied) or a coin.
Push the Allen bolt through the left side panel and
into the stabilizing bar. Start the threads by hand to
assure you don't strip the threads, then, use the
supplied Allen wrench.
Do not completely tighten the bolt at this step, you
will be asked to do this later.
FIGURE 1
opposite view
L
S
3
3
3
4
4
tenon
drilled
face
8
8
8
Summary of Contents for 401s
Page 2: ......
