Attention hazard of injury: Do not grasp in the grater! The grater is very sharp,
handle the grater with care to avoid injuries!
Only assemble the appliance at stillstand!
• Switch the appliance off – pull the mains plug!
How to assemble your appliance
• Remove the pulp container. For this, take the pulp container at the recessed grips and lift the
container slightly until it comes off the base lock. Afterwards tilt the container slightly and
remove it.
• Remove the pusher.
Remove the pusher from the fi lling hole.
• Remove the top cover.
For this, open the two locking clamps and fold them aside. Now, remove the top cover.
• Remove the juice container and the grater.
For this, fold the two locking clamps up. Grasp in the recesses of the clamps at both sides and
push the juice container up. Tilt the two locking clamps to the side again. Firstly remove the
grater with the micro-mesh fi lter carefully. For this, take the grater carefully at the rim of the
fi lter and lift it. Remove the juice container next.
• Disassemble the juice jug.
For this, remove the top cover of the juice jug. Afterwards pull the foam separator out.
• Attach the juice container.
Please take the juice container and place it on the intended bulge on the base unit.
• Attach grater with micro-mesh fi lter.
Take the grater carefully at the rim of the micro-mesh fi lter and place the grater on the gear.
Press against the rim of the grater with both thumbs until the grater engages. You will hear a
clear “click” when the parts engage.
Check the correct seat of the grater by turning!
• Attach and lock the top cover.
Please take the top cover and place it on the juice container. The fi lling hole must be centrally
19
