19
Vacuum-sealing with bags/rolls (width 30 cm)
This appliance can be used with bags with a width of up to 28 cm. In case you want to use bags with a
width of 30 cm, please proceed as follows:
Cut off slantwise one corner of the bag’s open edge
with scissors and seal this cut area.
Then, place the open edge of the bag in the vacuum
chamber and proceed with the vacuum-sealing process
as described before.
NOTE:
Check if the second sealing seam runs over the
first seam so that an “X” is created.
Cleaning and maintenance
WARNING! Always unplug the appliance before cleaning!
Never immerse upper casing, power cord and plug in water or
clean them under running water!
• Prior to cleaning the appliance or equipment, please wash your hands thoroughly.
• Clean the appliance and the vacuum chamber with a moist cloth and a mild dishwashing detergent
(no abrasives or solvents) before and after each use. Should any liquid get into the appliance, under no
circumstances connect the appliance to the mains, but contact your service point.
• The foam gaskets as well as the rubber lip can be removed for cleaning. Clean the gaskets and the
rubber lip with a damp sponge and mild dishwashing detergent.
• Allow the gaskets and the rubber lip to dry completely before attaching them again.
• When assembling, make sure the gaskets and the rubber lip fit correctly.
• Do not use any abrasives or solvents!
• Never use a steam jet appliance for cleaning!
Worn, deformed or damaged gaskets must be replaced in order to grant a proper working of the
appliance. Spare gaskets can be purchased at your service point.
Gaskets are wearing parts; therefore they are not covered by the appliance’s warranty.
Accessories
Use original Rommelsbacher bags/rolls with groove texture only.
The following accessories can be
purchased from your specialist shop:
Foil
bags
Foil
rolls
VBS 203 – 50x à 20 x 30 cm each
VRS 1560 – 2x à 15 x 600 cm each
VBS 304 – 50x à 30 x 40 cm each
VRS 2060 – 2x à 20 x 600 cm each
VRS 3060 – 2x á 30 x 600 cm each
