27
• Place the filled bag with the open end below the
stop angle of the vacuum chamber insert.
• Then close the lid of the appliance.
• For locking the lid, fold the handle down until it
snaps in.
Note:
This may cause a squeaking noise due to the
pressure equalisation.
• The appliance is ready for operation now.
2. Selecting operation mode
• By pressing the button
Lebensmittel
, the requested operation mode
can be set. The respective pilot lamp shows the selected setting.
• For dry food, select .
• For humid food, select .
• The standard pre-setting is .
3. Starting the automatic programme
• To start the programme, press the button
Automatik/Stopp
.
Note:
The operation can be stopped at any time by pressing the button
Automatik/Stopp
once again.
Note:
The appliance automatically stops after one minute of extraction
time, if the bag is not tight.
• The appliance activates the pump and extracts air from the bag, thus creating a vacuum.
The pilot lamp above the button
Automatik/Stopp
lights up
• After successful extraction of air, the pump stops and the sealing of the bag starts. Now the
pilot lamp above the button
Versiegeln
lights up additionally.
• As soon as this pilot lamp stops lighting, the process is completed. The appliance switches
to operation mode. Just one of the pilot lamps above the button
Lebensmittel
is lighting.
• In order to remove the bag, fold the handle upwards and then open the upper part of the
appliance up to the stop.
• Check the sealing seam. A correct seam should be a smooth straight line without wrinkles.
• After use, pull the power plug and bring the lid into storage position.
ATTENTION! For a safe switch-off, disconnect the appliance
from the mains after each use by pulling the power plug!
