WARNING
: This Projector is classified as a laser product. Do not look directly into the
beam. To avoid damage to the eyes, please avoid prolonged direct eye contact with the
product.
12.
Technical Specification
Size:
13L x 10.5W x 14cmH
Electrical Rating:
12V AC 250mA
Transformer:
I/P 230V~50Hz
O/P 12V AC 250mA
Laser product class II
Meets the requirements of EN61558-2-6
13.
Installation
Read all these instructions carefully BEFORE use, and familiarise yourself with these
as necessary.
Connect the adapter to the round one pin socket at the back of the base.
Place the Projector upright on a flat, stable surface. For indoor use in dry
environments only.
The Projector can be used, with or without the Diffuser Semi-Sphere Cap. Without
the cap, the visual effect can be projected onto a wall, as shown on the next page.
For best results, place the Projector 1 – 3 metres from the surface you’re projecting
onto.
Tilt the base as required to adjust the angle of the projection. This has a range of 45°.
Plug in the adapter. Switch on at the wall.
Switch ON using the circular ON/OFF button on the front of the base.
Do not leave the product unattended whilst in use. Always unplug the product from
the electrical outlet when not in use.
