13.
Installation
1.
Unpack the Manhattan II from the transportation crate.
Before you proceed any further, take a few moments to remove one key from each
key ring and label the keys you have removed – we recommend you attach a
coloured ribbon to each of these with a strong label on or write on the ribbon in
marker pen to identify these. For example, write ‘Manhattan’ on the label / ribbon
so that if you should ever lose these, you can identify them easily. As a further
failsafe, write on an adhesive label where the spares can be located and stick this
label to the top of the Manhattan or on the power cable – anywhere out of
immediate view but where it can be seen when looked for.
Keep the keys in a safe place and make a note for all users where this is.
You could keep one key from each ring in each lock, but this is not recommended
as removal of the keys will prevent any unwanted access to the waterless tube base
(bottom cupboard) and the controllers (upper cupboard).
We also recommend that you use an adhesive label to mark the remote control for
the music system as when you have several remote controllers together, one looks
just like the next. For example, write ‘Manhattan remote’ on the adhesive label
and stick it to the back of the remote controller (without compromising access to
the batteries).
2.
Connect the kettle lead to the 3-pin socket towards the bottom of the unit at the back.
Switch the ON/OFF switch next to this socket to ON.
