14.
Care and Maintenance
Wipe clean with a damp cloth.
Dry thoroughly immediately after wiping.
15.
Troubleshooting
If the Spinner fails to operate properly, please check the following:
Ensure batteries are properly positioned. The positive and negative ends are aligned with
those in the battery compartment.
Make sure that both ends of the batteries are touching the metal contacts in the battery
compartment and that the batteries being used have a full charge.
Ensure there are no obstructions which could prevent operation of the Spinner.
If there is a decrease in the number of spins, duration of the spins or an increase in the amount of
time you need to wait between activations then it is very likely that the batteries are likely to be
low in charge. Please replace these.
Further copies of these instructions can be downloaded at www.rompa.com
We hope you find our instructions invaluable. If you have any suggestions for improving
them further your comments will be greatly received – please contact us at
producthelp@rompa.com
SWITCH ACTIVATED SPINNER 21413, July 2015
Copyright ROMPA® Ltd
