Romus 93448, Manual Instruction

FIGURE 2 

PATIO HEATER ASSEMBLY

ASSEMBLY INSTRUCTIONS

z

List of Required Tools: 

    Philip Screwdriver / Adjustable Spanners / Wrenches 

z

Leak Detection Solution one part detergent and three parts 

water

z

Assemble all nuts and bolts loosely at first. Tighten all 

connections after completion of assembly. This eases your 

work and increases the stability of your appliance. 

z

Before assembly, make sure all packing material and any 

transmit protection must be moved. 

z

Small deviations in equipment may occur. This is no lack of 

quality but subject to improvements. 

ASSEMBLY

SETP 1: 

Screw rear panel of housing to the base with 5pcs bolts 

M5 x 12 and 5pcs washers. (Detail Abb. A) 

 Note:

 Start with two bolts at both ends of rear panel of 

housing, then three bolts in the middle, which will ease the 

assembly. 

SETP 2: 

Place the housing lid onto rear panel of housing. Screw 

together the housing lid and rear panel of housing with 

5pcs bolts M5 x 12 and 5pcs washers. (Detail Abb. B) 

SETP 3:   

Fix the post onto the housing lid with 4pcs bolts M5 x 12 

and 4pcs washers. Then put the plastic cover over the 

screws and bolts through the post. (Detail Abb. C) 

SETP 4:   

Place the reflector to main burner using 3pcs round cap 

nuts and 3pcs big washers. (Detail Abb. D) 

SETP 5:

Tighten inner gas pipe to main burner (See Figure 2), 

 Note:

 please examine the tightness before use. If 

damages are evident, they must be eliminated 

immediately. (See Leakage Test) 

Then fix main burner to the post with 3 bolts M5 x 12 and 

3pcs washers. (Detail Abb. E) 

SETP 6:

Fix the door to rear panel of housing. (See Figure 1 and 

Detail Abb. F) 

Detail Abb. A

Detail Abb. B

Detail Abb.C

Detail Abb. D

Detail Abb. E

Detail Abb. F