Romus 94570, Operating & Service Manual

Maintenance

MAINTAINING EQUIPMENT

Keep equipment in good repair by adopting a regular maintenance program. 
On a daily basis, complete the following:

•  examine the general condition of equipment. 
•  Inspect guards, switches, and cords for damage. 
•  Check for loose screws, misalignment, binding of moving parts, improper mounting, broken parts and any other conditions that may affect 

safe operation. 

If abnormal noise or vibration occurs, turn the equipment off immediately and have the problem corrected before further use. Do not use dam-

aged equipment. Tag damaged equipment “DO NOT USe” until repaired. 
During maintenance checks or regular inspections, complete the following:

•  Perform mechanical inspection.
•  Clean pulleys, spindles, bearings, housing, etc.
•  Perform electrical inspection (switch, cord, plugs, etc.).
•  Check nuts on shock absorbers and bottom plates.
• 

Check all screws and fittings for a tight and secure fit.

•  Sharpen dull blades. 
•  Clean dust and debris from vents. 
•  Keep the equipment handle clean, dry, and free of oil or grease. 

Use only mild soap and a damp cloth to clean. Some cleaning agents and solvents are harmful to plastic and insulated parts. Do not clean with: 

gasoline, turpentine, lacquer thinner, paint thinner, chlorinated cleaning solvents, ammonia, or any household detergents containing ammonia. 

Never use flammable or combustable solvents around equipment.

Note:

Machine is pressure washable. Motor, motor junction box, capacitor box, and switch are protected from splashes of water but must not be 

subjected to jets of high pressure. Thoroughly dry machine before use. Do not use machine when wet or damp.

14

WARNING:

 ALWAYS UNPLUG MACHINe BeFORe MAINTAINING. NeveR DISASSeMBLe THe TOOL OR TRY TO DO ANY ReWIRING 

ON THe TOOL’S eLeCTRICAL SYSTeM. FAILURe TO DO SO COULD CAUSe DAMAGe TO MACHINe OR SeRIOUS INJURY. CONTACT 

MANUFACTUReR FOR ALL RePAIRS.

401862-ROM_550-ROM_RevB