Mode d’emploi
QUATTRO BOOST MONOBROSSE 94450
INSTRUCTIONS FOR FITTING THE PLATE
Warning:
The machine should be disconnected from the electrical system while this operation is carried
out.
1. Lay the machine down on its wheels.
2. Then identify the location of the notches on the gear and in the ring gear on the plate.
3. Position the plate on the machine taking care to align the previously identified notches.
4. If the plate is not correctly positioned, go back to step 2.
5. Make a quarter-turn movement to lock the plate in place.
6. Fit the indexing finger and lock it with a quarter turn, thus ensuring that the plate is secure in all
situations.
Note: The above example describes the fitting of a 4D plate but the system also adapts to the use of a
spike plate or concrete plate.
INSTRUCTIONS FOR FITTING ABRASIVE DISCS ON THE 4D PLATE
Warning:
The machine should be disconnected from the electrical system while this operation is carried
out.
Warning:
Fitting abrasive discs is made easier with the use of Velcro-backed discs. Use only 150 mm
diameter "Norgrip" abrasive discs.
Warning:
For the best quality of work, it is recommended that all four discs are changed at the same
time.
8. RECOMMENDATIONS FOR PREVENTIVE MEASURES TO BE TAKEN BY THE USER
PERSONAL PROTECTION EQUIPMENT
Warning:
Sanding dust can spread through the air and be breathed in during use of the sander. Always
wear an FFP3 NR D protective mask against dust when using the sanding tool.
Warning:
There is a risk of serious injury to the eyes and/or body, if you do not wear protective
equipment and clothing when sanding. During any sanding operation, always wear safety glasses,
protective clothing and a dust mask.
Warning:
During any sanding operation, the intensity of the noise can cause hearing problems in cases of
prolonged exposure. Always wear hearing protection during any sanding operation.
Self-adhesive disc
Velcro base
Gear notch
Ring gear
Indexing finger
