4
The tool must neither be wet nor used in humid
environment.
Do not use the tool near explosive materials (petrol, dilution).
Modifications of the tool are prohibited.
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the
tool switch is off.
When the machine runs outside, always use a protection switch (30 mA
max.) against fault current.
The machine should only work under supervision of somebody. Plug
and switch the machine off if it is not under supervision, e. g. in case of
putting up and stripping down the machine, in case of setting up and
striking, voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Do not use the machine if one part of the housing is damaged or in
case of damages on the switch, cable or plug.
Electric tools have to be inspected by a specialist in regular intervals.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
During use, always hold the machine with both hands and
maintain a safe standing position. Pay attention to the reaction
moment of the machine.
For further safety instructions, please refer to the enclosure!
Before starting the machine check the correspondence between voltage
and frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The mixer is made in protection class II.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could lead to an excessive power loss and to an
overheating of motor and cable.
Electrical Connection
