6
!
The stirrer is equipped with an electronic switch. With this switch the speed
can be regulated according to the pressure on the button. Only use the
electronic switch when you want to start or stop the machine in order to
avoid material splashing around. Permanent use with reduced speed can
cause an overload because the motor then gets less cooling air and
therefore the machine will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only be appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points always have to be
observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorized
service workshop.
Attention!
Only press the arrestor button when using a
stand. In case of every stop of the machine, the
arrestor button has to be released immediately by
pressing the on/off switch. Consequently you can
avoid an unintentional restart of the machine
(physical hazard).
