Step 7
Press the Confirm button.
Step 8
Close the loading hatch
again without forcing it.
[2]
If it seems to resist, check
the position of the bottle.
Step 9
Once the bottles have been
detected, the top left LED
will flash.
Figure is ready to use.
IMPORTANT
At first use Figure will launch an
automatic cleaning
. It is required to wait until the end of the cycle before going to the
next step.
1.
The device has three spaces, so it is possible to load 2 bottles of BASE SERUM and 1 bottle of WASHING
SOLUTION.
2.
The device cannot dispense any treatment whilst the loading hatch is open.
RESET
Resetting Figures delete all configured settings of your formulateur (connection parameters, care
volume, stocks).
Reset Figure only if necessary.
Step 1
Unplug then plug back
Figure. Wait until it's on
again.
Step 2
Press simultaneously
Profile 1 and Profile 2
buttons for a few seconds.
Step 3
Wait for the 3 LEDs to flash
red alternatively before
connecting with the
application.