Rona 38115086, Operator'S Manual

Part Description 

Quantity 

Image 

AA

M6X35

Bolt

2PCS

BB

M6

Flat

washer

16

PCS

EE

M6X15

Screw

14

PCS

Hardware

Pack

3

Fig.17: Insert the short PC 1 (J3) Short PC 2 (J4) into the middle beam (I) and slanting beam (H), then insert the rails (N1 

and N2) into it. Insert the long PC (J1) into the middle beam (I) and slanting beam (H). Repeat this step to install the right 

PCs. 

Fig.18: Insert the middle PC (J5) into the middle beam (I); then insert the middle rail (N3) into it. Insert the middle PC (J5) 

into middle beam (I).   

Fig.19: Insert the plates (L1, L2 and L3) into the lower of the PCs; then secure the center plate (O1) to the middle beam (I) 

through three holes by using screws (EE) and flat washers (BB). 

Fig.20: Fig.20: Secure the corner plate (O2) to the slanting beam (H) through three holes by using screws (EE) and flat 

washers (BB). 

Fig.14:

 Insert the small PCs (K1 and K2) into the rail of the small slanting beam (S). 

Fig.15:

 Insert the plates (M1 and M2) into the lower of the small PCs (K1 and K2), then secure the corner plate 

(O2) to the small slanting beam (S) through three holes by using screws (EE) and flat washers (BB).   

Fig.16:

 Secure the cover (R) to the small top connector (Q) by using bolts (AA) and flat washers (BB).