1
FRANÇAIS
ENGLISH
070919
11. STORE IDLE EQUIPMENT.
Store
equipment in a dry area to inhibit rust.
Equipment also should be in a high location or locked up to keep out of
reach of children.
12. DON’T FORCE THE TOOL.
It
will do the job better and more safely at the
rate for which it was intended.
13. USE THE RIGHT TOOL.
Don’t force a small tool or attachment to do the
work of a larger industrial tool. Don’t use a tool for a purpose for which it was
not intended.
14. DRESS PROPERLY.
Don’t wear loose clothing or jewelry; they can be
caught in moving parts. Protective, non-electrically conductive gloves and
non-skid footwear are recommended when working. Wear protective hair
covering to contain long hair and keep it from harm.
15. USE EYE PROTECTION.
Use a full-face mask
if the work you’re doing
produces metal filings, dust or wood chips.
Goggles are acceptable in other
situations. Wear a clean dust mask if the work involves creating a lot of fine
or coarse dust.
16. SECURE WORK.
Use clamps or a vise to hold the work. It’s safer than
using your hands and it frees both hands to operate the tool.
17. DON’T OVERREACH.
Keep proper footing and balance at all times. Do not
reach over or across machines that are running.
18. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and safe performance.
Follow instructions for lubricating and changing accessories. Keep handles
dry, clean and free from oil and grease.
19. AVOID UNINTENTIONAL STARTING.
Be sure the switch is in the
OFF
position before plugging in.
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING
KEYS OR WRENCHES
before turning the tool on. Left attached, these parts
can fly off a rotating part and result in personal injury.
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF.
Have your tool repaired before using it.
22. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
ADJUSTMENTS.
Changing attachments or accessories can be dangerous if
the tool could accidentally start.
23. STAY ALERT.
Watch what you are doing & use common sense. Don’t
operate any tool when you are tired.
24. CHECK FOR DAMAGED PARTS.
Before using this tool, any part that
is damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment of moving
parts, binding of moving parts, breakage of parts, mountings, and other
conditions that may affect its operation. Inspect screws and tighten any
ones that are loose. Any part that is damaged should be properly repaired
or replaced by an authorized service center unless otherwise indicated
elsewhere in the instruction manual. Have defective switches replaced by an
authorized service center. Don’t use the tool if switch does not turn it on and
off properly.
25. REPLACEMENT PARTS.
When servicing, use only identical replacement
parts.
26. SERVICE AND REPAIRS
should be made by qualified repair technicians at
an authorized repair centre. Improperly repaired tools could cause serious
shock or injury.
1. COMPRESSED AIR CAUTIONS:
Compressed air from this unit may
contain carbon monoxide. The air produced is neither suitable for breathing
nor food processing without filtering and testing to all applicable legal
standards.
2. AIR ONLY:
Use this compressor for compressing air only. Do not compress
other gases.
IMPORTANT SAFETY INSTRUCTIONS
SAFETY PRECAUTIONS FOR COMPRESSORS
!
