VITREOUS CHINA VANITY TOP
REV. 160801
PRODUCT INSTALLATION
3
A RONBOW COMPANY
INSTALLATION (continued)
3
Installing the vanity top
It is highly recommended to have a second person for this
step.
□
Apply a small bead of silicone compound to the top
edge of the vanity. The silicone compound will act
as an adhesive to secure the top to the vanity.
□
Carry the vanity top to the vanity location and set
the top in place.
□
Always carry this product vertically to avoid excess
stress to the vanity top.
□ Place the vanity top into the final position as close
as possible. Avoid moving the top excessively after
setting into place.
□
Clean up any excess silicone compound with a
clean damp rag.
cabinet
4
Drying time
□
Allow at least 24 hours for the silicone to fully dry.
Refer to the silicone tube for instructions.
□
During this time avoid moving the vanity top.
DISCLAIMER
These instructions are for reference only. Due to the variety of installation situations, Aravo assumes no responsibility
for installation procedures, or damage to the products during installation. Aravo believes the average consumer can
install the product, but we recommend you consult with a professional. Proper safety and care should be taken during
installation to avoid injury.
CARE AND CLEANING
VITREOUS CHINA
Vitreous china vanity tops and sinks are very durable. The glazing process provides years of enjoyment if cared for
correctly. Rinse thoroughly and use a soft cloth to wipe the product dry after each use to prevent hard water stains. Soft
abrasive cleaners may be used when necessary to clean vitreous china products.
