•
4.3. Welding parameters
Wire diameter (mm)
Welding current (A)
Plate thickness (mm)
0.6
25-110
1.0-1.6
0.8
35-160(200)
1.0-2.3
0.9
45-160(200)
1.0-2.3
1.0
45-160(200)
1.2-6
•
4.4. Operation environment
Height above sea level ≤1000 M
Operation temperature range -10
~
+40
℃
.
Air relative humidity is below 90 %( 20
℃
).
Preferable site the machine some angles above the floor level, the maximum angle does
not exceed 15
℃
.
Protect the machine against heavy rain or in hot circumstance against direct sunshine.
The content of dust, acid, corrosive gas in the surrounding air or substance can not
exceed normal standard.
Take care that there is sufficient ventilation during welding. There is at least 30cm free
distance between the machine and wall.
•
4.5. Operation Notices
Read §1 carefully before attempting to use this equipment.
Connect the ground wire with the machine directly and refer to §3.5.
Ensure that the input is single-phase: 50/60Hz, 110V/220V±10%.
Before operation, no concerned people should be left. Do not watch the arc in
unprotected eyes.
Ensure good ventilation of the machine to improve duty ratio.
Turn off the engine when the operation finished for economize energy sources.
When power switch shuts off protectively because of failure. Don’t restart it until problem
is resolved. Otherwise, the range of problem will be extended.
In case of problems, contact your local dealer if no our authorized maintenance man.
Summary of Contents for Ronch Weld 200MP
