Protect other nearby personnel with suitable, non-flammable screening and /or warn
them not to watch the arc nor expose themselves to the arc rays or to hot spatter or
metal.
SELF-PROTECTION
Keep all equipment safety guards, covers and devices in position and in good repair. Keep
hands, hair, clothing and tools away from V-belts, gears, fans and all other moving parts
when starting, operating or repairing equipment.
Do not put your hands near the engine fan. Do not attempt to override the governor or
idler by pushing on the throttle control rods while the engine is running.
DO NOT
adds the fuel near an open flame welding arc or when the engine is running. Stop the
engine and allow it to cool before refueling to prevent spilled fuel from vaporizing on contact with
hot engine parts and igniting. Do not spill fuel when filling tank. If fuel is spilled, wipe it up and do
not start engine until fumes have been eliminated.
WELDING SPARKS can cause fire or explosion.
Remove fire hazards from the welding area. If this is not possible, cover them to prevent
the welding sparks from starting a fire. Remember that welding sparks and hot materials
from welding can easily go through small cracks and openings to adjacent areas. Avoid
welding near hydraulic lines. Have a fire extinguisher readily available.
Where compressed gases are to be used at the job site, special precautions should be
used to prevent hazardous situation.
When not welding, make certain no part of the electrode circuit is touching the work or
ground. Accidental contact can cause overheating and create a fire hazard.
Do not heat, cut or weld tanks, drums or containers until the proper steps have been
taken to insure that such procedures will not cause flammable or toxic vapors from
substances inside. They can cause an explosion even though they have been “cleaned”.
Vent hollow castings or containers before heating, cutting or welding. They may explode.
Sparks and spatter are thrown from the welding arc. Wear oil free protective garments
such as leather gloves, heavy shirt, cuff less trousers, high shoes and a cap over your hair.
Summary of Contents for Ronch Weld 200MP
