Technical Instructions 7004.N
Assembling
16 Mar 2010
6
2130.192
Date indicator maintaining plate
67.
Use 1 screw 4000.250.
4000.250
Screw
68.
3905.064
Date jumper spring
69.
Insert the spring into the opening of the date indicator maintaining
plate.
3907.047
Day finger flange
70.
"Turn the unit indicator forward by 30 days (quick mode). Then pull the
stem and adjust the time slowly until the date jump is executed ? after
the date jump stop turning the stem immediately! The ?half moon? cut
on the units indicator is now again pointing to the stem."
3004.211
Day finger
71.
"Position the day finger as indicated and turn the day finger until it is in
contact with the day cam. By this method the time gab between change
of date and change of day indicator can be minimized."
L
3004.212
Days driving wheel
72.
"Insert this wheel and assure, its bended down arm is properly inserted
into the counterpart on then Day finger. Make sure that during insertion
of this wheel, the Day finger is in contact with the day cam. This can be
done by slightly turning this wheel (counter clock wise) while inserting."
3401.082.FI
Day indicator pinion
73.
3147.062
Tens intermediate wheel
74.
3315.003
Hour wheel friction spring
75.
M
3504.231.AD
Tens indicator (T3/G6)
76.
The 'half moon' cut out on the tens indicator must point to the stem
(position 3h).
2130.193.G
Date mecanism maintaining plate (12h)
77.
Use 3 screws 4000.320.
4000.320
Screw
78.
3506.077.G
Dial support
79.
3506.076.G
Intermediate dial support
80.
N
9010.000
Moebius 8200
81.
Microgliss D5 can be used
9014.000
Moebius 9014
82.
Use Moebius 9014 on bearing of all rubis
9018.000
Jismaa 124
83.
Greace Moebius or Microgliss D5 an be used
9020.000
Moebius 9020
84.
