Air system
• Always use clean, dry, regulated, compressed air at 4.8 to 7.5 bar (70 to 110 PSI).
• Do not exceed the maximum or minimum pressures. Operating the tool at inappropriate pressure (too low or too high) will cause
excessive noise or rapid wear.
No.
Description
No.
Description
No.
Description
1
RONGPENG Air-powered Brand Nailer
5
Lubricator
8
Filter
2
Quick connector
6
Regulator 0–123 PSI
9
Cut-off valve
3
Quick coupler
7
(0–8.5bar)
10
Air compressor
4
Air hose
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Keep hands and other parts of the body away from the tool
’
s discharge and working areas when connecting the tool to the
air supply. Failure to comply could lead to serious injury or loss of life.
Read this Instruction Manual carefully before using the tool.
• Read and follow all the safety instructions at the beginning of this manual.
Inspect the Air-powered Brad Nailer prior to each use in order to:
– Ensure that the proper power source is being used.
– Verify that the tool is in proper working order.
– Verify that the air pressure level(s) are properly set on the air compressor.
• It is recommended that a filter-regulator-lubricator be used and be located as close to the tool as possible.
• If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic tool oil into the air inlet plug before each use.
• If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the air pressure to the tool, which will cause a
reduction in power, efficiency, and general performance.
• For optimal performance, install a quick connector to the tool and a quick coupler on the hose, if applicable.
• Verify that all connections in the air supply system are sealed in order to prevent air leakage.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Do not use the tool if it is not in proper working order.
• Do not use oxygen or any other combustible or bottled gas to power this tool.
• Do not use this tool in the presence of any flammable liquids or gases.
• Keep hands and other parts of the body away from the firing head during use.
• Do not point the tool towards the operator or other people.
• Do not attempt to clear a jammed nail when the air hose is connected.
• Do not drive a nail on top of an existing nail. Failure to comply could lead to serious injury or loss of life.
TYPES OF NAILS
This RONGPENG
Brad Nailer drives 18-gauge 5/8-2" (15-50 mm) long brad nails.
This nailer can be used with a variety of shank types (e.g., ring, smooth, spiral) and a
variety of coatings or nail compositions (e.g., Electro, mechanical, hot-dipped galvanized
or stainless steel, etc.).
WARNING!
Potential hazard that could result in serious injury or loss oflife.
• The use of any other types of nails will cause the nailer to jam and could
lead to serious injury or loss of life.
