13
Airless Sprayer Cleaning Procedure
When spraying tip is block-up, revolve it 180 degree for several times, then move back in position of
well-spraying.
Fig.5
Step 1: Engage trigger safety lock on gun. Revolve 180 degree
Step 2: Turn off pump and release fluid pressure by turning the pressure relief prime valve located on the engage trigger
safety lock on gun. side of the pump down.
Step 3: Engage trigger safety lock on gun, Revolve 180 degree then open the safety lock.
Pressure release procedure
Whenever instructed to relieve pressure, Stop spraying, Check or service equipment or install or clean
spray tip.
1. Engage trigger safety lock on gun. Turn Off power and turn sprayer pressure control to lowest pressure setting.
2.
Hold gun against side of flushing pail. Trigger gun into pail to relieve pressure.
3. Turn off pump and release fluid pressure by turning the pressure relief prime valve located on the
side of the pump down.
Daily Maintain
Equipment lifetime is rely on daily maintain. The following respects should be obeyed:
1. Read the Manual carefully before first using.
2. Check the electrical requirement before each working.
3. Thorough cleaning equipment and the accessories after using.
4. Coil the tube after cleaning, in case of any damage.
5. Add some lubricant if long time not use
