IMPACT DRILL
8
- Set the direction switch to the correct direction.
- Never change the direction of motion when the machine is switched on.
CARE OF THE TOOLS
.
OVERLOAD
Never use excessive force when drilling. Too much pressure reduces
the speed of the machine, and the required power is greatly reduced.
This may result in overload, which can damage the motor of the drilling
machine. When the drilling machine becomes too hot, allow it to run for
two minutes without a loud and then interrupt working for a short time.
Clean the drilling machine with a clean cloth and a brush. Ensure that
the ventilation slits not blocked.
This appliance conforms to CE directive for radio interference
suppression and low-voltage safety and has been built to meet current
safety requirements. Subject to technical changes without prior notice!
Summary of Contents for 2210C
Page 1: ...IMPACT DRILL 13 mm 2210C ...
Page 10: ......
