USER MANUAL
15
CAUTION:
Sometimes the tool does not begin the striking stroke even when the
motor rotates this may be because the oil has become thick
Due to low temperature or has been standing idle for long period. Run
the chisel for approx 5 minutes to bring the oil temperature up.
MAINTENANCE
.
OIL FEEDING
CAUTION:
Prior to oil feeding, always disconnect the plug from the power supply
receptacle. Since an oil chamber is built in this electric hammer chisel, it
can be used for approximately 20 days without supplying lubrication oil,
assuming that the chisel is used continuously 3-4 hours daily.
Feed oil into the oil tank as described below before using the hammer chisel.
1) When the chisel is held upright look through the oil gauge window to
see if oil is visible, if no oil shows oil must be installed before operating.
If chisel is used without oil this could seriously damaged the chisel and
forfeit any warranty given.
2) Before feeding oil, use the provided wrench to remove the oil
gauge (4). Be careful not to lose the rubber packing attached below
the oil gauge.
3) Check the oil level once daily, confirming that oil is filled.
4) After feeding oil, securely clamp the oil gauge.
NOTE:
Oil for the electric hammer chisel is sold separately, use Shell oil
ROTELLA 40 (engine oil) or equivalent, this is sold at most shops or
filling stations anywhere.
