USER MANUAL
13
out to remove debris.
This chisel does not have torque facility. It is not recommended
to use any other bit other than masonry or chisels do not use
metal cutting drills, this could cause serious injury.
NOTE:
chiseling for an extended period of time may cause the chisel
motor to overheat. If the chisel gets hot, stop chiseling and allow
it to cool for at least 15 minutes.
.
PRECAUTIONS ON USING ELECTRIC HAMMER CHISEL
1) Before using the electric hammer chisel always make sure
the oil supply is to the full level and the screw is tight.
2) This electric hammer chisel has a fixed handle always make
sure the screws holding the handle are secure before operation
takes place. Always use both hands when using this chisel failure
to adhere to this could invite injuries.
3) Safe operation, always make sure you have a stable posture
and safe footing before operating the electric hammer chisel.
4) When working at a high level, always make sure that no person
or persons are below you, as this could invite injuries to those
persons under you.
5) Before starting any job like breaking, chipping a wall, floor or
ceiling, thoroughly confirm that no items such as an electric cable,
water pipe or conduit are buried inside as this could cause injury
or flooding.
6) Properly set the bit holder.
7) The bit can become very hot during operation exercise extreme
caution as this could cause injury.
8) Always wear protective safety glasses
9) Always wear ear defenders or earplugs
