USER MANUAL
5
branch, ground or other obstruction. Remove or avoid any obstructions
that might impact the tip of the guide bar while cutting (Fig.3).
- DO NOT cut more than one log or branch at a time.
- DO NOT twist the saw when removing the guide bar from an undercut
while bucking.
- DO NOT operate the unit with one hand! Serious injury to the operator,
helpers or bystanders may result from one-handed operation. this unit is
intended for two-handed use. Always grip the unit firmly with both hands
when the engine is running. Keep the left hand on the front handle and
the right hand on the rear handle. Use a firm grip with ghumbs and
fingers encircling the handles. A firm grip will help maintain control of the
unit and reduce kickback.
- DO NOT install a bow guide on this unit. Bow guides havea larger
kickback zone, which increases the chance of kickback and serious
injury. This increased risk is not significantly reduced by using a low
kickback saw chain.
Using a bow guide on this unit is extremely dangerous. Never start the
saw when the guide bar is inside an existing cut. Be extremely careful
when re-entering a cut.
Keep proper footing and balance at all times.
- Always begin a cut with the engine running a full speed. Fully squeeze
the throttle control trigger and maintain a steady cutting speed. Slower
speeds increase the chance of kickback. Keep the saw housing pressed
firmly against the wood.
- Watch for shifting logs, branches, or other objects that might pinch, or
fall onto the chain while cutting.
- If using wedges, Only use wedges made of plastic or wood. Do not use
metal to hold a cut open.
- Follow the manufacturer’s sharpening and maintenance instructions
for the saw chain.
- Only use replacement guide bars and chains specified by the
manufacturer or the equivalent.
These are available from authorized service dealers. Use of any
