USER MANUAL
7
running. Before starting the saw, make sure the saw chain is not
contacting anything.
- Always stop the engine when operation is delayed, before setting down
the unit or when walking from one location to another. Make sure the
chain comes to a complete stop. Do not leave the unit unattended while
the engine is running. Always stop the engine when not in use.
- To avoid accidental starting, never carry the unit with fingers on the
throttle control trigger. Only pull the starter rope when in the starting
position. The operator and unit must be in a stable position while starting
the engine. Refer to Starting and stopping instructinos.
- Always carry the chain saw by the front handle with the engine off,
finger off the throttle control trigger, the muffler positioned away from the
body and the guide bar and saw chain sheathed in the scabbard and
positioned to the rear.
- Always make sure the stop switch is in the proper position before
starting or stopping the engine.
- When cutting a limb that is under tension, be alert for spring back,
which may cause the operator to be struck when the tension of the wood
fibers is cause the operator to be struck when the tension of the wood
fibers is released.
- Use extreme caution when cutting small-sized brush and saplings, as
slender material may catch the saw chain and be whipped toward the
operator or pull the operator off balance.
MAINTENANCE AND STORAGE SAFETY
If the unit is not working as it should, has been dropped, damaged,
left outdoors or dropped into water, do not use the unit. Have the unit
serviced by an authorized service center.
All service, other than the maintenance procedures described in this
manual, should be performed by an authorized service center.
Follow all maintenance instructions in this manual.
Before inspecting, servicing, cleaning, storing, transporting or replacing any
