PRODUCT MANUAL
68/72ST Below Deck Compact Motor
™
8
STEP 2
Install the deck plate
2.1 A stainless steel deck plate [7] is included with the Compact
Motor™ unit. The drilling template [A3] can be used to identify
the locations on deck for the mounting holes and deck cut-outs.
The self-tailing arm of the winch can be adjusted after installation
into one of eight different positions as indicated on the drilling
template.
2.2 Use the drilling template as a guide for preparing the deck.
Ensure that the mounting surface is flat and there is adequate
space and clearance on deck for the winch base and below
deck for the motor. With the drilling template in the desired
orientation, drill or cut the Ø86mm (3 3/8’’) hole for the motor
drive shaft housing.
2.3 Drill the Ø10.5mm holes for the M10 deck plate mounting bolts
(13/32” holes for 3/8” bolts).
2.4 Clean any wood or fibreglass splinters from the holes, and clean
the deck thoroughly to ensure deck sealant can adhere properly.
2.5 Apply sealant to the deck where the deck plate will be fixed. For
aluminium boats use a galvanic isolating ring/gasket.
2.6 Fit the deck plate to the deck using appropriate length M10 or
3/8” countersunk head bolts, large washers or backing plate, and
locking nuts.
Typical self-tailing arm positions
Deck plate mounting
