RF25109HL Series 20 BB Orbit Block
™
Lashing Head User Instructions
(cont.)
USER INFORMATION - RF25109HL Series 20 BB Orbit Block™ Lashing Head User Instructions
Page 4.
2.3 SINGLE LINE USED AS BECKET & SHEETS - FOR SHEETS UP TO 3MM (1/8”)
2.3.1
Pass the line in
through a cheek, up
through the head,
around the fixing
point, back down
through the head
and out through the
opposite cheek.
LASHING ATTACHMENT
•
To receive the maximum performance benefit from the Lashings, they must be used correctly installed, inspected regularly and replaced
when required.
•
Lashings must be attached to a mounting point with a smooth, well rounded profile without sharp edges or burrs. If in doubt, use a
shackle with a smooth surface between the Lashing and the mounting point.
•
Lashings will eventually suffer degradation from fatigue, wear and UV exposure. Like all running and standing rigging, Lashings should be
inspected as a part of your regular boat maintenance program and replaced if they show significant wear or fibre damage.
ORBIT BLOCKS™
•
Grit and sand will damage bearing systems. Ronstan Orbit Blocks™ have a precisely engineered bearing system that should be kept clean
and free of sand and grit to ensure optimum performance and service life. Blocks, in particular the bearing areas, should be flushed with
fresh water regularly and periodically cleaned with a mild detergent and water.
•
Dry lubricants such as Ronstan Sailfast™ silicon spray may be used to lubricate the bearing system. Oil/petrochemical based lubricants
must not be used.
•
Ronstan Orbit Blocks™ are designed and manufactured for applications on sailboats.
•
See the INFO section of the Ronstan web site and our catalogue for important customer considerations and warranty information.
BB = Ball Bearing
MWL = Maximum Working Load
BL = Breaking Load
Dyneema® is a trademark of Royal DSM NV.
DSM is the inventor and manufacturer of Dyneema®, the world’s strongest fibre™. “Dyneema®”, and “Dyneema®, the world’s
strongest fibre™” are trademark(s) (applications) owned by Royal DSM NV.
2.3.2
Pass both ends
through the hub in
opposite directions.
2.3.3
Finish lashing with appropriate knot, splice or whipping. If a knot is
used it must not be a ‘slip’ knot, and the knot must be such that it pulls
equally on each line leading up to the hub. A bowline is ideal. Note: the
breaking load of the installed block is dependent on the breaking load of
the line; up to a maximum B.L. of 900kg (1980lb). Knots, splices, stitching,
etc. will generally have a lower breaking load than the rope itself.
3.0 CARE AND MAINTENANCE
4.0 DEFINITIONS
