Rooboost RB-2000, User Manual

1.  

Connect the jumper connector (blue) into the RB-2000 jump start socket.

     Wait for jumper cable display to go into stand-by mode. When in stand-by

     status, (           ) is ON and flashing in a circular mo�on, it shows that the

     RB-2000 is ready for jump star�ng.

•

   Turn ON the RB-2000 by pressing its (     ). Make sure it is over 25% charged.

•

   Make sure all of the vehicle’s power loads (headlights, air condi�oning, radio,

     etc.) are turned off before a�emp�ng to jump start the vehicle.

•

   Ensure that the ba�ery is 12 V lead-acid before connec�ng the jump starter to

     the ba�ery. The RB-2000 is not suitable for any other type of ba�ery.

•   

Iden�fy the correct polarity of the ba�ery terminals on the vehicle ba�ery.

•

   Ensure to not make any connec�ons to carbure�or, fuel lines or thin-sheet

     metal parts.

•

   Follow the below steps carefully to jump start your vehicle.

HOW TO JUMP START A VEHICLE

2.  

Connect the jumper clamps to the vehicle ba�ery terminals appropriately to

     avoid reverse polarity connec�on. Ensure that the ba�ery terminals are clean.

     Connect posi�ve (red) jumper clamp to the posi�ve ba�ery terminal and

     nega�ve (black) jumper clamp to the nega�ve ba�ery terminal.

     If the jumper cable display shows voltage without any warning or alarm beeps, it

     indicates that the vehicle is ready for jump star�ng.

9