6
Assembly & Use Instructions
Make sure you have read through the sections - Operating
Precautions (p. 4) and Care Instructions listed above - before
assembling and using your distiller.
Distiller Assembly & Use
1.
Remove your new Water Distiller from the box and packaging and
check that all items are included and in good condition. Refer to the
diagram on p. 3 for a list of all parts.
2.
Wash all parts of the distiller thoroughly by
hand, including the hose and clamp, in warm
soapy water, and rinse carefully.
3.
Once clean, take the water pan and fill it with
water up to the line and place it on your stove-
top. (See diagram at right)
4.
Next, place the collector pan on top of the
water pan. Squeeze the clamp and slide it to
the center of the hose. (See diagram at right)
5.
Then place the condenser pan on top of the
collector pan and fill the condenser pan all the
way to the top with cold water. (See diagram at
right)
7.
Do NOT place a lid or anything else on top of
the condenser pan. The water in the condenser
must be able to evaporate to provide the
cooling needed for the distiller to work
properly.
8.
After correctly assembling your distiller, turn
on the burner unit to the High position.
Be sure to always use heat protective gloves or mitts while
working with your distiller. The steam is very hot and will burn
you.
