Page 12
Installation and commissioning
© 2017 Ropam Elektronik
Wiring system.
System cabling should be made using low voltage cables. In addition, it should comply with the
regulations and standards in particular: cable type selection and cross-section, 230V / AC wiring
distance,
Other connections should be made according to the manufacturer's instructions and if not, you can
use the following cables:
• YTDY, YTLZ,
• UTP, STP, FTP,
• YTSKY,
• Other low current compliant with regulations and standards.
Installation and commissioning procedure.
1. Make complete wiring: signal and power supply,
2. Install the enclosure and insert the wiring through the cable glands,
3. Install the SIM card in the module (the card must not be installed while the power is on!),
- insert horizontally into the SIMCARD connector, the gold-plated SIM card towards the PCB, the SIM
card (notch) must be pointing at the slot in the SIM card slot on the module board.
Below is a view of the SIM card installation process in BasicGSM 2 / BasicGSM - PS 2 - Profile view.
4. Install the board and modules in the enclosure:
a) in the system housings (Ropam) on the pins included,
b) in the enclosures of the control panel transmitters on the self-adhesive pins supplied with the
module,
c) in the control cabinets with the latch fixing the DIN housing on the mounting rail.
5. Optional additional modules:
- for VSR connectors: VSR-2, VSR-2 + AMR-1 or VSR-1 or AMR-1,
- to the T1 connector: TSR-xx,
