Roper Whitney - Model 3617 Crimping & Beading Machine Manual
CAUTION: DO NOT OPERATE MACHINE WITHOUT PROPER INSTRUCTIONS.
Observe all safety rules and regulations. Become familiar with controls and intended operation
before using. MACHINE MUST BE SECURELY BOLTED TO FLOOR and connected to correct
source of voltage, phase and cycles.
WARNING: Electrical danger -- Misuse or improper installation of machinery connected to a
source of electricity may result in accidental shock that could cause injury or death. Installation
must conform to National Electric Code (Article 250 - Grounding, etc.) Ground all electrically
powered equipment. Machine to be operated by qualified personnel only.
WARNING: KEEP HANDS AND FINGERS CLEAR OF ROLLS AT ALL TIMES.
Provide point of operation guarding as required to avoid injury. The exact guard needed will be
governed by many factors and may require change when going from one cylinder to another. All
required guarding to be installed and effective before using. Some of the factors involved are:
Diameter of cylinder, length of cylinder, type and gauge of material, direction of feed, number of
passes thru rolls, etc. Do not allow clothing or any part of the body (fingers, hands, arms, hair, etc.)
to come in contact with the rolls while the machine is operating. Do not use machine if servicing is
required. Never adjust machine with power on. Be alert to all potential hazards.
-14-
H. WEISS MACHINERY & SUPPLY
H. WEISS MACHINERY & SUPPLY
PHONE: (718) 605-0395 - www.hweiss.com
