Roper Whitney - Model 3617 Crimping & Beading Machine Manual
ROPER WHITNEY COMPANY
SAFETY RULES
NO. 3617
1.
WARNING:
Electrical Danger -- Misuse or improper installation of machinery connected to a source of
electricity may result in accidental shock that could cause injury or death. Installation must
conform to National Electric Code (Article 250-Grounding, etc.)
Electrical connections must be made by a trained and qualified electrician. Electrical
characteristics shown on motor plate and control panel must match the power source; and
all electrically powered equipment must be grounded.
2.
WARNING:
Mechanical Danger -- The power driven forming rolls will rotate in either a clockwise or
counter clockwise direction. Never place any part of the body including loose clothing near
or onto the rotating rolls. (KEEP HANDS AWAY). Failure to comply will lead to personal
body injury.
3.
Never clean forming rolls while rolls are rotating -- turn power off to clean rolls.
4.
Machine to be operated by authorized personnel who have been trained by their supervisor
with the working and safety features of the machine, and by reading and understanding the
Operator’s Manual.
5.
Do not operate power crimping and beading machine without reading Operator’s Manual
and without proper supervisory instructions.
6.
Perform all installation and set-up operations before applying power for electrical start-up.
7.
Never operate machine with any guard removed; i.e., all required guarding to be installed
and effective. Do not override the safety features of the equipment. Do not remove, paint
over, alter, or deface any machine-mounted warning and instruction plates and signs.
8.
Never leave machine running unattended. When not in use, turn off electrical power.
9.
Never adjust machine with power on.
10.
Avoid accidental start-up.
11.
Do not use machine if servicing is required.
-3-
H. WEISS MACHINERY & SUPPLY
H. WEISS MACHINERY & SUPPLY
PHONE: (718) 605-0395 - www.hweiss.com
