Chapter 2: Hardware Installation
2-19
Profile:
The drive trays accommodate 3.5-inch-wide x 1-inch-high
hard drives.
Drive type:
This model accommodates 6Gb/s SAS or 3Gb/s SATA
hard drives.
WARNING!
1. Handle hard drives with extreme care. Hard drives are very
delicate. Dropping a drive against a hard surface (even from a
short distance) and hitting or touching the circuit board on the
drives with your tools may cause damage to the drives.
2. Observe all ESD prevention methods when installing drives.
3. Only use screws supplied with the drive canisters. Longer
screws can damage the hard drives.
2.8.2 Drive Installation
Step 1.
Place the hard drive into the drive tray
(as shown
below), making sure that the interface connector is
facing the open side of the drive tray, and the label side
facing up.
Installing a Hard Drive
Step 2.
Adjust the drive’s location
until the mounting holes in
the drive canister are aligned with those on the hard
drive.