CHAPTER 5 – TROUBLE SHOOTING
10
PROBLEM:
THE CLUTCH SLIPS AND THE TAP CANNOT BE TURNED:
Probable reasons
Solution
1.- Clutch slackness
= Clutch adjustment (page 11)
2.- No tool lubrication
= Use cutting oil
3.- inappropriate tap for the material
= Use the correct tap according to material and
manufacturer’s advice
4.- Tap spoiled, “worn”
5.- Misaligned hole
6.- Drilled hole diameter too small
PROBLEM: THE LUBRICATION SYSTEM FAILS TO OPERATE
Probable reasons
Solution
1.- The oil reservoir is empty
= Fill the reservoir (see page 6)
2.- The oil-hole is clogged
= Unscrew the end of the lubrication nipple and clean
it. (ATTENTION: Do not mislay the spring and the
ball located inside)
IMPORTANT:
If the oil reservoir has been fully emptied the circuit will have possibly been filled with air, so that
after having filled the reservoir it is necessary to start the motor several times in succession in a
state of the highest setting position of the lubrication regulating control.
Main features of the cutting oil type to be used:
Use pure cutting oil without additives.
- Viscosity: 20-40 cSt.
- Additives E.P. –extreme pressure- (Sulphur, Phosphorous and Chlorine inactives)
- It does not contain solvents
WARRANTY
The warranty period for the machine is 12 months. The warranty does not cover any
damage caused by overloads, wear and improper handling of the machine. The
warranty covers the labouring costs and damaged spare parts. The transport,
packaging and assurances as well as the defect caused by the use of not original
replacement parts are at customers’ costs.
The same warranty period will be applied for the purchase of original spare parts such as,
dampers, motors or electric boards.
Any attempt of repairing the machine without the previous authorization of TECNOSPIRO
MACHINE TOOL shallcause the lost of its warranty period.
Some accessories such us tapholders are not included on warranty since they are conside
red perishable.
Summary of Contents for MOSQUITO
