p. 4
DMX IRIS OPERATIONS MANUAL
One Channel Operation Two Channel Operation
(2nd Ch = speed)
Mode 1: Open to Close (0-255) Mode 3:
Ch 1 = Open to Close (0-255)
Ch 2 = Speed (0-100%)
Mode 2: Close to Open (0-255) Mode 4:
Ch 1 = Close to Open (0-255)
Ch 2 = Speed (0-100%)
Setting DMX Address and Operation Mode
On power up, the DMX Iris will restore to the last set mode and dmx address.
The display will indicate these parameters as in Figure 2.
To change Operation Modes, press and hold button
B1
for a few seconds
until the display changes to
SET
. Press
B1
until the Left digit of the display
display indicates the desired Mode 1, 2, 3, or 4.
Use buttons
B2
(100s),
B3
(10s), and
B4
(1s) to set the 3 digit DMX address of
the unit.
Press and hold
B2
to SAVE the new settings. After saving new settings, the
disply will indicate
boot
and then go into the homing sequence.
To run a self-test mode, press and hold
B4
A switch to the right of the display allows you to adjust the brightness of the
display.
Modes
DMX Address
Modes
x100
x10
x1
Setup
Save
Test
B1
B2
B3
B4
1. 0 0 1
Installing the DMX Iris in your luminaire
The DMX Iris has been designed to fit into most modern ellipsoidal
luminaires. With its thin body design and customized toolings, the list
of compatible fixtures includes ETC Source Four, ETC Source Four Zoom,
Selecon Pacific, Altman Shakespeare, Strand SL, Leviton Leo and many
