Parts
Step 5
Screw posts onto screw tabs and
tighten.
Fig. 6
Note: Use the end of the post with
the smaller opening.
Step 6
Insert one screw into the middle
opening on each screw base and into
the post.
Fig 7
Tighten with screwdriver.
Fig. 8
Step 7
Install screw bases using wood screws
and screwdriver.
Fig. 9
Note: Togglebolts are recommended
for drywall installations (predrilling
3/8” holes is necessary)
Step 8
Slide your graphic into the AnoFrame.
Fig. 10
Instructions For Assembly
Incept-9.06.02
Figure 6
The AnoFrame VersaMount is a trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss
or damage resulting from the use of these products.
Part #02INSVersaMountScrewBaseSQ
Finished Look
Instruction Sheet (page 2 of 2)
AnoFrame VersaMount
TM
Screw Base
Figure 7
Figure 8
Figure 9
Figure
10
#97-0451SQ
